V1
23
Winton WAM
Filters
Check the filters located on the entry and exit of the fuel tank. Replace these if needed.
Other Maintenance
Blades: Check condition of the blades and replace if worn/broken. Always take care when handling
blades, wear gloves and use suitable tools for changing blades. If blades are replaced check they are
balanced in order to avoid any excessive vibration.
Oils: Ensure oil levels are checked and topped up when needed. Replace any oils and filters per the
schedule.
PTO Shaft: Check the condition of your PTO shaft and replace if worn or damaged immediately.
Cleaning: Ensure the cutter is cleaned of grass. Remove debris from any moving parts to prevent
entanglement. Do not spray water on bearings when cleaning with a high pressure washer.
Bearings: Check the bearings on the blade rotor and roller. If seals are damaged replace bearings.
Run the mower without a load for 3-5 minutes to check bearings are operating smoothly.
Paintwork: Re-coat any damaged paintwork to prevent corrosion.
Storage: Store the machine in a dry, level area. Support the frame if necessary.
The periods recommended are based on normal operating conditions. Severe or unusual conditions
may require more frequent maintenance.
9. SERVICING & MAINTENANCE (continued)
Safety: Store all lubricants away from excessive heat, dust, moisture and contaminants.
Safety: Ensure tractor and machine is stopped & keys out of ignition before set-up/maintenance.
Filter Check
Check filters every 50 hours/yearly
First Filter Change
Replace after first 50 hours use (or as needed)
Filter Change Frequency
Replace every 250 hours (or as needed)
4
Summary of Contents for WAM Series
Page 40: ...www wintonmachinery co uk ...