Winterthur Gas X40-B, Maintenance Manual

Page: 89 / 495

Maintenance
1132 − 2/A1
Winterthur Gas & Diesel Ltd.
3/ 15
Note: The instructions given below are
also shown on the plate (394110,
Fig. 4 ).
1) Attach the lug (94116B) to the bearing
cover (4) with the 8.8/M10x30 screws.
2) Make sure that the thrust device (94110)
is clean.
3) Apply copper paste to the spindle and
face of the special screw (7).
4) Make sure that the piston (6) is in the
initial position.
5) Put the thrust device (94110) in position
on the bearing cover (4).
6) Open the vent screw (5).
7) Connect the HP hoses (94935) to the
connection (1) on the hydraulic ram (2)
and the HP oil pump (94931).
8) Refer to 9403 − 2 to connect the HP hose
(94935) and the pressure gauge.
9) Operate the HP oil pump until oil that has
no air flows out.
10) Close the vent screw (5).
11) Operate the the HP oil pump (94110) to
get a pressure of 1500 bar.
12) Tighten the special screw (7) to lock the
piston (6).
13) On the HP oil pump, operate the relief
valve to release the pressure.
14) Disconnect the HP hose from the
connection (1) on the hydraulic ram (2).
4. Main Bearing Cover
No. 1 − Removal
1) Attach the manual ratchet (H2, Fig. 5 ) to
the lug (94116B).
2) Operate the manual ratchet (H2) to lift
the bearing cover (1) to a sufficient
height.
2016
Main Bearing − Removal and Installation
CONNECTION
REFER TO
9403 − 2
COPPER
PASTE
6 7
1
WCH00909
94116B
5
94110
Fig. 4
Fig. 5
1
H2
2
4
3
1