Winterthur Gas X40-B, Maintenance Manual

Page: 101 / 495

Maintenance
1132 − 2/A1
Winterthur Gas & Diesel Ltd.
15/ 15
1) Clean the pipes (1, Fig. 19 ).
2) Install the pipes (1), their gaskets and new tab washers (4).
3) Tighten the screws (3).
4) Lock the screws (3) with the new tab washers (4).
5) Remove all tools from the engine and below the flywheel.
9. Main Bearing − Lubrication
After an overhaul of the bearing shells, more lubricant can be added to prevent damage
to the surface of the bearing shells. Refer to the Operation Manual, 0320 − 1 Lubricating
Oils.
1) To fill the bearing shell with the lubricant do the procedure that follows:
a) Remove the blank flange (6 ) .
b) Remove the screw plug (5).
c) Fill the bearing shell with the applicable lubricant.
d) Install the screw plug (5).
e) Install the blank flange (6).
2) Remove all tools and equipment from the work area.
1 5
3, 4
2
WCH00597
6
Fig. 19
Main Bearing − Removal and Installation
2016