Winterthur Gas X40-B, Maintenance Manual

Page: 71 / 495

Maintenance
0380--1/A1
Winterthur Gas & Diesel Ltd.
9/ 9
Group Component Applicable Maintenance Intervals
9
9223--1
Crank Angle
Sensor Unit -- Replace proximity sensor as necessary
Oil mist detector -- Follow manufacturer’s instructions half yearly
UNIC electronic
components -- Replace the modules: CCM--20, MCM--11 and
LDU--20, see operation manual 4002--1.
66000
-- Replace exhaust valve stroke sensor and TDC
sensors if defective
66000 (replacement if
required)
-- Do a visual check of the cables and wiring.
Replace damaged cables and wires
quarterly
Tool service
pump -- Do a functional check of the hydraulic pump a
minimum of one time each year
In accordance with the
manufacturer’s
instructions
The indicated maintenance intervals must be taken as guidance and can be different.
The correct intervals are related to the data below. These intervals can be extended
or decreased.
1) Environmental and operation conditions
2) Heavy fuel oil and lubricating oil qualities (refer to the Operation Manual 0710--1
and 0750--1).
3) Engine load.
4) Fuel, lubricating oil and cooling water (see Operation Manual 0720--1 and
0760--1)
5) Do overhauls in accordance with the Maintenance Manual.
6) Correct spare parts used.
7) Monitor the engine.
8) Engines in accordance with specifications of Winterthur Gas & Diesel Ltd,
Switzerland.
The sectional drawings in 0803--1 have all the areas shown with their group numbers.
2020
Inspection and Overhaul Intervals (Guidelines)