5
If scanned-out channel is not priority channel, transceiver will
leave it for 3 sec. and will stay standby on priority channel to
check if there is any signal. It will change to " SCAN CH " after 3
sec. from the end of reception or radio-communication. While
there is no signal and if [PTT] is pushed, transmission is done
from priority channel.
If scanned-out the signal, transmission is done from busy
channel. It will again go on scanning after 5 seconds at the end
of reception or radio-communication.
※
W hen scanning, m onitor the current channel if press
[Monitoring]. It will again go on scanning after releasing
[Monitoring] 5 seconds.
※
In the case of no signal or press the [PTT] or [Monitoring],
LED lamp will be flashing green to indicate in scanning.
※
VOX is invalid, when scan in progress.
※
This function is not allowed a
t the [CTCSS / DCS OFF] / [Talk
around] / [TX power adjustment].
VOX ON / OFF
To activate this function, press and hold PTT and push [P0]
simultaneously. To deactivate, repeat the same procedure. A
ding-dong melody will be heard at the end of activation and
deactivation of VOX.
※
While VOX is enabled, press of [PTT] is no longer required
during transmission. Just talk into the microphone area with
appropriate sound (depending on VOX sensitivity).
Summary of Contents for LP-4604+
Page 1: ...LP 4611 User s Manual...
