Wintec LP-4604+, User Manual

Page: 7 / 18

3
Assignment of channels
※ Program the
frequency of channels in advance.

There are channels 1 ~ 16 selectable by Channel knob.

If select any unedited channel, speaker sounds beeps and
LED lamp stays on red.

If no mark the option " Do not lock the channel knob when
the key is locked " when programming, it will lock all
keypads and unable to rotate channel knob. Once adjust
channel knob, the speaker sounds beeps continuously and
LED stays on red lamp.
Scan Channels
To activate this function, need to assign “ Normal SCAN ” in
programming key setting.
Long press defined key enables start or stop scanning.
During programming, assign desired channels as " Scan CH".
EX: If channels CH1, CH2, CH5, CH9, CH12 are assigned as "
Scan CH", these channels will be scanned in this sequence
continuously till a busy channel is found.
Transceiver will stay on that busy channel for reception or to
transmit and according to "SCAN setting" (BR/TR) to decide on
when can again go on scanning. BR: Till signal disappears for 3
seconds to continue scanning. TR: Staying on the busy channel
exceed setting (3/5/10sec.), transceiver will continue scanning
no matter the signal disappears or not. While there is no signal
and if [PTT] is pushed, transmission is done from self original
channel.
If scanned-out the signal, transmission is done from busy