Wintec G-Trender, User Manual

Page: 109 / 216

108
(position, time and number of satellites acquisitioned) is
different from the new area. It will need longer time for re-
positioning.
When the power LED flashes red, the battery is critically
low and needs re-charging. If it is not recharged within
30~100 min, G-Trender will stop to work to prevent total
exhaust of power.
PIN code will be requested after Bluetooth connection
initiates between GPS and Pocket PC. Enter code as 0000.
Avoid placing 2 GPS devices too close during positioning.
Bluetooth connection takes 5 seconds for self-check.
Each time the device is switched on; it needs 5 seconds
before connection.
It is normal if the Bluetooth coverage might become short
sometimes due to environmental interferences.
USB driver must be installed first before connecting the
device to the USB port of computer. Make sure of the right
Com Port being used.
If disconnection between Pocket PC and GPS is done in a
abnormal way, Pocket PC will halt. Try to disconnect
Bluetooth connection in a standard method.
If the G-Trender is found to work abnormally because of
wrong procedure, reset it by taking off the battery. It will
have factory default without effecting pre-set program. At
the factory default, GPS reception begins in a warm start
mode and its position may take longer time.
If G-Trender is used for navigation but found unworkable
after connection is done. Make sure the format of
NMEA0183 that the software used match up G-Trender
export format.