15
14
15.Attention for reapter mode
Please attend to the following points while
operating this function.
1. ( 10) select "+" or "-"
2. ( 13)select the discrepancy of span by 0.6MHz
or select any of settings but it will be invalid if
exceeding the frequency ranges of the radios.
3. Be sure to enable the CTCSS tone. Some
repeater need to open up CTCSS tone.
4. Turn off REV TX/RX function ( 5) if possible to
decrease the interference for the transmission and
receiving frequency.
※
Frequency span for VHF is 600KHz (default 6)
※
Frequency span for UHF is 4MHz (default 40)
16.Swift setting for REV TX/RX Reverse
Holding , temporarily press to enable REV
reverse function. Press again to turn off this
function.
※
This function can only work when the repeater (
10) is on.
17.Function Setting Lock/Unlock
Enabling Function Setting Lock can keep the
setting as original ones when power off. Press
+ and then turn on the power. Let go of all
buttons after 3 beep sounds. The function is
locked. When this function is enabled, all of the
functions include CTCSS code, quick VOX, swift
setting REV cannot be adjusted besides
frequencies, CHs, and volume.To unlock, turn off
the power and press + and then turn on the
power.
Let go of all buttons after 1 beep sounds to restore
the operation.
18.Keeping MEM channel
MEM channel can be stored in a long period of
time.Keep the channel in advance and then turn
off the power, Press + and turn on the
power, let go of all buttons after 3 beep sounds.
The memorization is enabled. To disable,repeat
the same steps when power off. Let go of all
buttons after 1 beep sounds.
※
This function does not work while there is no M Ch.
