ITX-M-CC452-T10/Configuration
v1.0
www.winsystems.com
Page 12
6.2
Configuration and Installation
When installing a Type 10 COM module onto a compatible COM Express
Type 10 carrier board, follow the instructions below to ensure that there is
no damage to the COM module or the carrier board.
1. Align the COM module standoffs with the mounting holes on the
carrier board.
2. Ensure that the COM Express Type 10 mini interface connector is nicely
seated in the COMe connector socket on the carrier board.
3. Apply pressure to the red region denoted in the following figure.
NOTE To minimize board flex on the carrier board, make sure the carrier board is
supported on the opposite side prior to applying pressure to the COM
module.
4. Insert and tighten down the screws supplied with your COM
module’s heat spreader/ heat sink.
Avoid Electrostatic Discharge (ESD)
Only handle the circuit board and other bare electronics when electrostatic
discharge (ESD) protection is in place. Having a wrist strap and a fully grounded
workstation is the minimum ESD protection required before the ESD seal on
the product bag is broken.