2-23
SECTION 2
DRIVING YOUR MOTOR HOME
·
Do not open any of the four T-handled valves
on the opposite end of the pump. These regu-
late the coach leveling jacks.
Step 2 - Crank Room Inward
·
A wheel (lug) nut wrench is used to crank the
room inward. You may use the wrench sup-
plied wth the coach (in one of the storage
compartments) or any type of lug wrench of
the same nut size.
·
Crank-in bolts are located on the outboard
mounting plates of the slideout room as
shown. These plates are located at both ends
of the room inside the StoreMore
TM
compart-
ment doors.
·
Loosen the stop bolt beneath the crank-in bolt
as shown before trying to turn the bolts.
·
After loosening the stop bolts, fit the lug
wrench socket onto the bolt head and begin
cranking clockwise slowly a few turns, then
alternate to the other side for a few turns. This
can be sped up by using a helper and an addi-
tional lug wrench to crank both sides evenly
together.
Crank the tire wench clockwise slowly, until
the room is fully retracted. Allow about 10
minutes to crank room in fully.
NOTE: Attempting to crank the room in too
quickly will raise pressure in the hydrau-
lic fluid lines and make cranking more
difficult.
Step 3 - Secure Travel Straps and Close
Hydraulic Line Valves
·
Fasten the slideout room Travel Straps as
shown on page 2-20.
·
Tighten the slideout valve nuts completely.
NOTE: Close the valves snugly, but do not over-
tighten. Overtightening nuts may cause
internal damage to the valves.
·
See your dealer for service of the room exten-
sion system before using again.
Further Information
See the HWH Hydraulic Room Extension op-
erating guide included in your InfoCase for fur-
ther instructions and troubleshooting
information.
Bedroom Slideout Emergency
Retraction
In the unlikely event that your bedroom slide-
out fails to retract using the power switch, check
for obvious causes first, such as low charge on
Crack-in Bolt
Stop Bolt