![background image](http://html1.mh-extra.com/html/winnebago/solis-2020/solis-2020_manual_987512050.webp)
SECTION 7 –
PLUMBING
7-2
4. Turn OFF city water supply and disconnect
hose from the Tank Fill Inlet.
5. Set the Water Panel back to the “Dry
Camping” setting.
ECO-HOT SYSTEM
When placed in the “Pre-heat” setting the Eco-
hot System cycles water as it gets hot, to avoid
wasting water into the gray tank. To operate, turn
the water pump on, then turn the Eco-hot valve to
the “Pre-heat” position. After approximately 6
seconds, the water should be hot. Then place the
Eco-hot valve to the “Normal” position.
WATER PUMP
When your motorhome is not connected to a
city water supply, water is supplied from the
fresh water tank by a water system demand
pump. A demand pump is designed to run only
when you are using water. When you open a
faucet, the waterline pressure drops and the pump
begins to run, and it will continue to run as long
as the faucet is open. When you close the faucet,
the line pressure backs up to the pump, and it
shuts itself off.
The pump is self-priming and will run briefly
to build up line pressure when the Water Pump
switch is first turned on. See “Initial Waterline
Priming” for instructions on using the water
system for the first time.
Water Pump Strainer
The pump is equipped with a cleanable
strainer to capture any possible tank-borne
particles that could damage pump components.
NOTICE
Do not leave fresh water connection
unattended when filling tank. Failure to
comply may result in tank expansion and
property damage.
Tank water level indicator- depress button
above to view water level in low light
conditions. Can be left on to be used as a
night light. (located on sink cabinet)
-Typical View
Eco-hot valve
-Typical View