SECTION 3 –
DRIVING YOUR MOTORHOME
3-2
Adjustment:
To lengthen belt, swivel the tab end at a right
angle to belt and pull strap to desired length. To
shorten, pull loose end of belt.
To Fasten:
Be sure belt is not twisted. Grasp each part of
the belt assembly and push tongue into buckle.
Adjust to a snug fit by pulling the loose end away
from the tongue.
To Release:
Press button in center of buckle and slide
tongue out of buckle.
Lap/Shoulder Belts
Refer to the chassis manual provided in your
InfoCase for instructions on proper fastening,
adjustment, and releasing of lap/shoulder belts.
Seat Belt Care and Cleaning
•
Be careful not to damage the belt webbing and
hardware. Take care not to pinch them in the
seat or doors.
•
Inspect the belts and hardware periodically.
Check for cuts, frays, and loose parts.
Damaged parts should be replaced. Do not
remove or modify the belt system.
•
Keep belts clean and dry. If the belts need
cleaning, use only a mild soap and water
solution. Do not use hot water. Do not use
abrasive cleaners, bleach, or dyes. These
products may weaken the belts.
•
Replace any belt assembly that was used
during a severe impact. Replace the complete
assembly even if damage is not apparent.
KEYS
Your motorhome is supplied with several
keys. In addition to the chassis manufacturer’s
ignition key, you receive keys for the entrance
door and exterior compartment doors.
Keys have an identification number, either a
small metal tag or stamped into the key head.
These numbers are recorded on the vehicle’s
component model/serial sheet, which is included
in your InfoCase. In case keys are lost or stolen,
your dealer or a locksmith can provide you with
duplicate keys or modify the locks.
REMOTE KEYLESS ENTRY
The cab doors on your vehicle are featured
with a chassis-supplied Remote Keyless Entry
system, which you can lock and unlock these
doors using the provided keyless remote
transmitter.
WARNING
Snug and low belt positions are essential.
This will ensure that the force exerted by
the lap belt in a collision is spread over the
strong hip area and not across the
abdomen, which could result in serious
injury.
Only seats equipped with seat belts are to
be occupied while vehicle is in motion.
Swivel seats must be in the locked,
forward facing position while vehicle is in
motion.
1- Insert tab into buckle
slot until it “clicks” and is
locked
2- Pull strap to tighten
3- Press to
release