3-7
SECTION 3 –
DRIVING YOUR MOTORHOME
Further Information
Refer to the chassis manual provided in your
InfoCase for complete information and
precautions.
LIGHTS
All exterior lights should be checked for
proper operation each time the vehicle is
prepared for a trip. Any bulbs which fail to light
should be checked and replaced, when necessary,
with a new bulb of the same size. A failure of
more than one light, such as both taillights not
operating, may indicate a burned out fuse. Check
fuse and replace with one of the same rating
when necessary. If a fuse is not the cause of the
problem, the wiring system should be checked
immediately by an authorized service center.
Further Information
Refer to the chassis manual in your InfoCase
for further information.
VALVE STEM ACCESS
(Mercedes-Benz
®
Sprinter Chassis)
Front Wheel Valve Stem Access on
18-Hole Steel Wheel with Push-On
Full Wheel Trim
–If Equipped
1. Obtain a double angle push/pull truck tire
gauge.
2. Locate the 6” hose extension (provided in
your InfoCase).
3. Push the end of the hose extension onto the
front wheel valve stem cap.
4. Using the hose extension as a remote handle,
unscrew the valve stem cap (retaining cap in
the end of the hose extension).
5. Adequate clearance is available to insert the
tire gauge onto valve stem.
Diesel Exhaust Fluid Fill
(Located under front hood)
-Typical installation shown
