SECTION 2 –
SAFETY AND PRECAUTIONS
2-12
Check for valve stem location and the valve
stem clearance notch (located on the back side of
the front cover).
Under the front cover is the chassis supplied
black center cover. The recessed area has three
alternating silver washers. Removal of the three
nuts on top of the three washers will allow the
removal of the center cover while the wheel is
still retained to the hub with the remaining three
nuts.
When re-installing the front liner, make sure
to align the stem clearance notch on the back of
the liner with the valve stem.
When installing the liner, be sure it is engaged
all around the perimeter (outside edge) equally.
Note: If the edge on one side is pushed in before
the other, it may be difficult to complete
the push on procedure.
Further Information
See the chassis manufacturer’s user guide
provided in your InfoCase for complete
instructions and re-torque information.
Valve Stem Clearance Notch
Valve Stem Clearance Notch aligned to Valve
Stem
Clearance Notch
Valve Stem
WARNING
If the notch is not aligned with the valve
stem, the valve stem may be damaged
which could deflate the tire causing
steering or handling problems.
WARNING
DO NOT operate the vehicle with less
than all 6 nuts installed and properly
torqued.
Chassis Supplied Wheel and Center Cover