2-15
SECTION 2
DRIVING YOUR MOTOR HOME
·
The circuit breaker may be tripped. The cir-
cuit breaker, labeled ‘Slideout Power’ is lo-
cated on a panel on an interior wall of the
passenger side storage compartment just be-
hind or ahead of the entrance door.
TROUBLESHOOTING - Problems Retract-
ing the Room
Set the Park Brake if the red Park Brake light
flashes while pressing the Retract button.
If an error is detected on your DigiSync Room
Slide System, the green LED on the left side of
the control panel will blink an error code. If an
error code appears, see the On Board diagnostics
section to determine the problem. The error code
must be cleared prior to operating the room. To
clear the error, press the “RESET” button with a
small tool such as a toothpick. Before operating
the room after an error has been detected, check
for obvious faults such as obstructions prior to
trying to operate the room again. If the error code
appears again, the room will need to be retracted
using either the semi-manual retraction method
or the fully manual method. Both methods listed
below are intended as a means to retract the room
to prepare the coach for travel to the nearest au-
thorized Service Center.
To retract the room after an error is detected,
you override the synchronization programming
and operate the room in the Semi-Manual Mode.
Semi-Manual Mode:
Semi-Manual Mode lets you individually
move the two room arms by pressing the IN and
OUT buttons on the control pad.
This mode can
be used only if there is not a motor failure or full
electrical system failure.
To override the encoder
and enter the Semi-Manual Mode, press and hold
the RESET button until the two LEDs begin to
flash.
While in the Semi-Manual Mode each of the
two, room slide arms are activated by pressing
and holding the IN and OUT buttons. The “OUT”
button will retract the front arm. The “IN” button
will retract the back arm. Both IN and OUT but-
tons may be held down at the same time to simul-
taneously activate both arms to retract the room.
If one side of the room gets ahead of the other, re-
lease that button until the other arm catches up.
The current limiting feature of the control still
functions in the Semi-Manual Mode so each side
can be fully retracted until it stops.
Once the room has been retracted, the control
will return to the automatic mode after 60 sec-
onds. You can manually return to automatic
mode by pressing the stop button.
In the event of a total system failure where
Semi-Manual Mode cannot be used, two crank
handles may be used to retract or extend the
room.
Crank-In Mode
:
If the room will not retract using the buttons
and the mechanism is apparently malfunctioning,
you may need to manually crank the room in to
the travel position. The cranks are stored on clips
on the wall of the right rear cargo compartment.
Green light will flash
error code, if system malfunctions*
Dianostics
Reset Button*
Red light will flash if park
brake not set.
*Not equipped on single mechanism systems
Never let one side get more than 2
inches (50 mm) ahead of the other
while retracting.
CAUTION
