![background image](http://html1.mh-extra.com/html/winnebago/impulse-24v/impulse-24v_user-manual_987488051.webp)
4-9
SECTION 4 –
APPLIANCES AND SYSTEMS
FURNACE – PROPANE GAS
–If Equipped
To Start Up
1. Turn ON the LP Tank valve switch.
2. Press the MODE button to select Heat and
press the Temp Selector button (up/down
arrows) until the desired temperature is shown
on the display.
3. The furnace fan should start to blow
immediately after setting the thermostat.
4. After approximately 30 seconds, the furnace
burner should light.
5. The furnace should now cycle off and on
automatically as the thermostat demands just
like a household furnace.
If heat does not come out of the heat ducts
after a minute or so, the burner is not lit.
Turn the thermostat OFF for 3-5 minutes,
ensure Propane Gas Tank switch is on and tank is
not empty, then repeat Steps 2-4.
If the furnace will not light after three
attempts, go to “Shut Down” steps and contact
your dealer or a local RV service center for
repair.
NOTE: If the furnace burner has any residuals
of metal protectant or lubricants used
during manufacture of the furnace, it
may smoke slightly when the furnace is
used for the first time and may set off
your smoke alarm.
We recommend that you provide
adequate ventilation when using the
furnace for the first time to avoid a
nuisance smoke alarm.
We do not recommend removing the
smoke alarm battery.
To Shut Down
•
Press the MODE button to select OFF.
•
Turn OFF Propane Gas Tank switch if coach
will be stored for a period of time.
Further Information
Refer to the manufacturer’s user guide
provided in your InfoCase for further
information, including operating precautions,
and periodic maintenance. See “Coach
Maintenance Chart” in S
ection 11 - Maintenance
and Storage
for recommended intervals.
LP Tank
Valve
Switch
MODE
• Press MODE
button to select
Heat.
Temp Selector buttons
• Press the UP arrow to
increase temperature.
• Press the DOWN arrow
to decrease
temperature.
NOTE: Press any button once to wake the
thermostat display.