![background image](http://html1.mh-extra.com/html/winnebago/chalet-27cr2006/chalet-27cr2006_manual_987474036.webp)
SECTION 6
– Appliances and Equipment
6-2
Class A
The above switch turns the refrigerator On or
OFf. If the switch is slid to AUTO, it will turn the
refrigerator On and run in automatic mode.
The temperature selector switch controls the
refrigerator and freezer temperature during both
gas and electric operation. Slide the switch to
select the desired temperature setting.
When set to AUTO mode, the refrigerator will
automatically use 110-volt power if the shoreline
is plugged in or generator running. If 110-volt
power is not available, the refrigerator will
automatically switch to run on LP gas.
NOTE: The power cord must be plugged into the
generator receptacle for generator
operation.
If an operating mode is not functional, its
corresponding indicator will flash and the
refrigerator will attempt to operate in a lower
power priority source. If a lower power priority
source is not available, the indicator will continue
to flash, and the refrigerator will cease operation
until the energy source is corrected. Refer to the
“Diagnostic” section of the “Norcold
Refrigerator Operator’s Guide” in your InfoCase.
Auto and Manual Modes - Gas
Operation Only
If the gas does not ignite within 30 seconds,
which may occur on initial start-up, the
refrigerator’s gas valve will automatically close
and the operating controls will select an alternate
power source (AUTO Mode) or revert to a stand-
by mode in which the GAS indicator flashes. The
indicator continues to flash until the refrigerator
is turned OFF and then ON. If the gas does not
ignite after several attempts, check the input gas
supply, or consult with your dealer or an
authorized service center.
Backup Operating System (“BOS”)
Your refrigerator features a Backup Operating
System which keeps the refrigerator cool in the
event of a failure of the refrigerator’s operating
controls. If a failure occurs, the TEMP SET LED
flashes and refrigerator switches to the BOS
mode. This mode provides refrigeration until the
refrigerator is serviced. The fresh food and
freezer compartment temperatures should be
monitored to prevent over-freezing or thawing of
refrigerator contents when operating in the BOS
mode. If the refrigerator temperature is too cold,
adjust the thermostat to the left in single LED
increments. If the refrigerator temperature is too
warm, adjust the thermostat to the right in single
LED increments. Let the refrigerator operate at
the new setting for one hour before rechecking
the freezer and fresh food compartment
temperatures. (Frequent door opening prevents
the temperatures from stabilizing.) Although the
refrigerator can operate in this mode, have
refrigerator serviced to restore manual operation
as soon as practical.
Operating Tips
•
The refrigerator should already be cold before
placing items in it.
•
Food and beverages should also be cold
before placing in RV refrigerator. Never put
warm or hot items in a cold refrigerator.