![background image](http://html1.mh-extra.com/html/winnebago/2014-sightseer/2014-sightseer_operators-manual_987455085.webp)
7-13
SECTION 7 –
PLUMBING
•
Twist the filter cartridge “counter-clockwise”
about a quarter-turn and pull it down and out
of the filter socket.
NOTE: The water filter head has a built-in
bypass. No separate diverter plug is
needed.
Set Up Winterization Valves
2. Turn the Water Heater Bypass valve to
BYPASS position.
3. Remove and save the protective cap from the
end of the antifreeze siphon tube.
4. Insert the end of the antifreeze siphon tube
into a pail or other container with 2 to 3
gallons of non-toxic RV antifreeze solution.
5. Turn the Winterization valve so that it points
toward the antifreeze siphon tube.
NOTE: Ensure that all drain valves are
CLOSED before pumping RV antifreeze
into the water system.
Refer to the “Water System Drain Valve
Locations” chart at the end of this
section for valve locations on your
model.
Fill Lines
6. Turn the Water Pump switch on.
7. Open each hot and cold water faucet handle in
the coach - one at a time, until antifreeze
solution just begins to flow from the faucet,
then close.
Do not forget the exterior shower/wash station
knobs (if equipped).
8. Press the toilet flush pedal and hold until
antifreeze begins flowing into the toilet.
Leave small amount of antifreeze that remains
in the bowl.
When Done Adding RV Antifreeze
9. Turn Water Pump switch off.
Ice Maker Water Filter Assembly
(Located below galley sink)
Antifreeze
Siphon Tube
• Insert into
container of
RV water
system
antifreeze
Winterization
Valve
• Point toward
antifreeze
siphon tube
for winterizing
Antifreeze Siphon Tube and
Winterization Valve
-Typical View
(See the “Water System Drain Valve
Locations” chart at the end of this
section for location on your model)