6-9
SECTION 6
ELECTRICAL SYSTEMS
CB RADIO WIRING
(Optional)
If your coach is pre-wired for CB radio instal-
lation, the wires are located in the main wiring
harness beneath the instrument pod. Lift the in-
strument pod as shown to access the wiring har-
ness.
Look for a pair of wires, purple (+) and green
(-), with flag labels.
Be sure to read the wire labels before install-
ing a CB radio. The labels contain important in-
formation and cautions.
SWR Adjustment
To adjust CB antenna SWR (standing wave
ratio), turn the adjusting ring of the antenna to
achieve lowest SWR reading. This procedure
will help optimize transmitting and receiving ca-
pabilities of the CB radio system.
TRAILER WIRING CONNECTOR
Your coach is pre-wired for trailer or car tow-
ing lights with a 6-pin socket on the rear bumper.
The connector plug is supplied in the coach parts
package provided to you by your dealer when
you took delivery of the vehicle.
The diagram shows proper connection of trail-
er or tow vehicle wiring to the coach light system.
Remove the small screw near the end of the plug
and slide the contact assembly out of the barrel.
CB Radio Wiring
TO
CB RADIO
RED BLK
TO
CB RADIO WIRING
LABEL
CB ANTENNA
CABLE
WIRE ASM-IP, MAIN
CB POWER PROVISON
PURPLE +12 V
GREEN GROUND
COAX ANTENNA
(SEE REVERSE ALSO)
The CB radio could become damaged
if the CB antenna SWR is not
adjusted before operating the CB
radio.
CAUTION