Winmate M-Series, User Manual

Page: 31 / 112

USER MANUAL CHAPTER 2 GETTING STARTED
- 31 -
2.4 Configuring Serial Port Settings
Serial Port can be configured for RS-232, RS-422 or RS-485. Jumpers are
located on the motherboard. You need to open the housing in order to access the
jumpers.
CAUTION/ ATTENTION
It is recommended to use factory jumper settings. Opening the
housing when it is sealed may damage the device and its parts.
Il est recommandé d’utiliser la configuration d’usine de cavalier.
Ouvrir le chassis lorsqu’il est scellé peut endommagé l’appareil et
ses pièces.
NOTE:
A pair of needle nose pliers may be helpful when working with
jumpers. If you have any doubts about the best hardware
configuration for your application, contact your local distributor or
sales representative before you make any changes. Generally,
you simply need a standard cable to make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on
both pins, the jumper is SHORT. The illustration below shows a 3-pin jumper;
pins 1 and 2 are short. If you remove the jumper cap, the jumper is OPEN.
PIN 1-2 SHORT
PIN 3 OPEN
Both Jumper 8 and Jumper 9 allow setting the Serial Port COM1 configuration.
Refer to the table below for PIN assignment.
Example: To make RS-232 Settings, set the Jumper 8 Pin 1-2 to the SHORT
position, and Jumper 9 Pin1-2, 4-5, 7-8, 10-11 to the SHORT position.