Winmate IP70, User Manual

Page: 16 / 88

16 IP70 Mini-ITX SBC User Manual
outlet. The Display Port connector is a standard 20-pin DP connector.
2.3.5 Ethernet Interface
The IP70 Mini-ITX SBC is equipped with Intel® I210AT Gigabit-LAN Cont I219LM Gigabit-LAN
PHY which is fully compliant with the PCI 10/100/1000 Mbps Ethernet protocol compatible. It is
supported by major network operating systems. The Ethernet ports provide two standard RJ-45 jacks.
2.3.6 USB Port
Eight USB devices (four with pin headers) may be connected to the system though an adapter cable.
Various adapters may come with USB ports. USB usually connect the external system to the system.
The USB ports support hot plug-in connection. Whatever, you should install the device driver before you
use the device.
2.3.7 Audio
The Audio 7.1 channel capabilities are provided by a Realtek chipset supporting digital audio outputs.
The audio interface includes two jacks: line-out and mic-in.
2.4 Jumper Settings
This section explains how to set jumpers for correct configuration of the motherboard.
Note:
A pair of needle nose pliers may be helpful when working with jumpers. If you
have any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes. Generally, you
simply need a standard cable to make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins, the jumper is
SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short. If you remove the jumper
cap, the jumper is OPEN.
PIN 1-2 SHORT
PIN 3 OPEN
Caution
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.