Winmate IF70 Mini-ITX SBC, User Manual

Page: 19 / 96

19
1BChapter 2: Hardware Installation
2.4 Jumper Settings
This section explains how to set jumpers for correct configuration of the motherboard.
NOTE:
A pair of needle nose pliers may be helpful when working with jumpers. If you have
any doubts about the best hardware configuration for your application, contact your
local distributor or sales representative before you make any changes. Generally,
you simply need a standard cable to make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins, the
jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short. If you
remove the jumper cap, the jumper is OPEN.
PIN 1-2 SHORT
PIN 3 OPEN
CAUTION
To avoid damaging the module, always turn off the power supply
before setting jumpers or clearing CMOS.
Jumpers
Label
Function Note
JP1 Panel Power Select 2x3 header, pitch 2.0mm
JP2 BackLight Power Select 1x3 header, pitch 2.0mm
JP3 Backlight Dimming Select 1x3 header, pitch 2.0mm
JP4
Backlight Dimming Control
Select
1x3 header, pitch 2.0mm
JP5 MCU ISP Burnin to Select 1x3 header, pitch 2.0mm