Winget 2B1500, Operators Handbook & Parts, Page: 32 / 170

Every 10 operating hours, or daily
Check for leaks
Check for oil leaks around joints and
seals.
Every 50 operating hours, or
weekly
Tighten securing nuts
Tighten axle arm/main case joint securing
nuts and half shaft nuts.
Axle oil level
Do not check the oil level until the
machine has stood for 2 minutes.
Clean the area surrounding level/filler plug
(D) before removing it.
The oil is correct when level with the
bottom of the level/filler plug hole.
If the level is low, top-up with clean oil of the
correct grade through the hole.
Replace plug (D).
For the correct type and grade of oil,
see "Specifications".
Every 1000 operating hours
Axle oil change
Change the lubrication oil in the front axle
as follows:
Clean the areas surrounding the
level/filler plug
(D), and drain plug (E) .
Place a suitable container beneath
the drain plug.
CAUTION: Before removing the plugs be
sure to stand to one side to avoid the oil
that will spill from the drain hole.
Remove drain plug (E) and drain oil
from the casing. Replace drain plug.
Refill at the level/filler hole (D) with clean
oil of the correct grade.
The level is correct when oil reaches
the bottom of the hole.
Replace plug (D).
For the correct type and grade of oil,
see "Specifications".
SERVICE 3.9
FRONT AXLE