Marine Installation Manual
2021-08
1-8
1 Engine Summary
1.3 Fuel operating modes
X72DF
Power meter requirement
The X-DF engines require the installation of a power meter on the shaft. This is
to measure necessary parameters (see
).
Table 1
-
6
Power meter parameters
1.3.2
Operation in diesel mode
In general, diesel mode is always available. If the gas system fails or the engine
output in gas operation mode is insufficient, the diesel mode provides opera
-
tional flexibility and a fail-safe.
The main fuel injectors inject the main fuel, while the pilot fuel micro-injectors
remain in operation at a reduced injection rate to avoid clogging of the nozzles
(approximately 0.5 % of total fuel consumption in diesel mode). The main fuel
can be changed over from either MDO or MGO to HFO. Before changing back
to gas mode, the main fuel needs to be changed back to diesel oil (see section
).
For engine operation on distillate fuels, see the following Concept Guidance
(DG 9723), as provided on the WinGD webpage:
Abbreviation
Value
Parameter
A
±
0.5%
Sensor accuracy
U
≤
1.0s
Update rate
D
≤
0.5s
Delay
S
≥
10Hz
Sampling rate
ES
4-20mA
Electrical signal