WinGD RT-flex50DF, Maintenance Manual, Page: 133 / 586

Maintenance
2124 − 2/A1
Winterthur Gas & Diesel Ltd.
5/ 8
3. Water Guide Jacket −
Removal
1) Remove the cylinder liner, refer to the
procedures in paragraph 1 to
paragraph 2.2 .
2) Loosen the two screws (3, Fig. 7 ).
3) Remove the cylinder holders (4, 5).
4) Attach the three shackles (94018D) to
the lifting tool (94201).
5) Attach the three eye bolts to the water
guide jacket (1).
6) Attach the three manual ratchets
(94016 − 004) to the three eye bolts (8)
and the shackles (94018D).
7) Apply a light tension to the manual
ratchets (94016 − 004).
8) Remove the three bolts (9) that hold
the water guide jacket to the cylinder
liner.
Note: During step 9 ), make sure that you
do not cause damage the top of
the cylinder liner.
9) Operate the manual ratchets
(94016 − 004) to lower the water guide
jacket (1).
10) If the water guide jacket (2) does not
come away from the cylinder liner, do
step a ) and step b ):
a) Put three applicable M12 screws
in the threaded holes of the
holder (7).
b) Turn equally the three M12 screws
to push down the water guide
jacket.
11) Operate the manual ratchets
(94016 − 004) to lower the water guide
jacket on to a wooden underlay. Make
sure that you keep the water guide
jacket level.
12) Remove the manual ratchets
(94016 − 004) from the three eye bolts
(8) and the shackles (94018D).
13) Attach the lifting tool (94201) to the
cylinder liner (see paragraph 2.1 ).
14) Carefully lift then move the cylinder
liner to a different position.
2016
Cylinder Liner: Removal and Fitting
1
94016 − 004
WCH02913
94202L
94201
94018D
8
WCH030059
WCH03086
9
Fig. 7
2
1
3
4
5
3
6
7
Note: Some parts
can look different