Removing Old Driver & Application
If your computer has been installed the old WinFast TV2000 XP driver and software, you
must remove them before installing the new WinFast TV2000 XP capture card.
Stepl:
Go to the Start menu and click Setup.
On the Setup submenu click Control
Panel to open an explorer on which
many programs are listed. Double click
the Add or Remove Programs to open
a setup panel with a list of software
installed on your system. Select
WinFast PVR (Application). And then
click the Change/ Remove button.
Step 2:
Once the application is uninstalled, go
back to the Add or Remove Programs
setup panel. Select WinFast TV2000
XP/VC100 XP (WDM Driver) and then
click the Change/Remove button.
Step 3:
When the old driver is removed, restart
the computer.
Hardware Installation
Stepl:
Power off your PC. Open the computer
case. Remove the coverplate of an
unused expansion slot.
Step 2:
Align the bus on the card with the PCI slot.
Step 3:
Gently press WinFast TV2000 XP down
into the slot until you feel the edge of the
bus reaches the bottom of the PCI slot.
Note that the capture card can be inserted
into PCI slot in one direction only.
Step 4:
Secure the bracket of the card to your
computer case with the screws. Then fit
the computer case cover back in place.
Step 5:
Connect the input sources and output
devices to your capture card following the
instructions given in Connecting Input
and Output Devices on the next page.
Now you are ready to connect the video
sources to your capture card.
