P a g e
|
33
6.
CALIBRATION screen -
This screen will state that a calibration is not required and this is usually the case
since a calibration was performed at the factory prior to shipping.
a)
If you select “No” you will be taken to the CALIBRATE COMPASS screen on item
7.
b)
If you select “Yes” the following screen will appear:
i.
If “NEXT” is selected, the controller will exit the Calibration without any
movement and proceed to the next step in the configuration described on
item 7.
ii.
If you select “GO” then the Calibration will begin.
Summary of Contents for WX980
Page 10: ...P a g e 10 3 Open lids on both sides as shown below ...
Page 19: ...P a g e 19 ...
Page 56: ...P a g e 56 ...
Page 81: ...P a g e 81 9 4 Wiring Diagram User Supplied Device ...
