If you had to raise the antenna with the emergency manual stow drive,
follow the instructions below for calibrating the elevation motor.
From the installation menu, press
[SELECT]
to move the asterisk to “Calibrate EL”;
then, press
[ENTER]
.
Press
[SELECT]
to move the asterisk to “Yes.”
Press
[ENTER]
to start the elevation calibration procedure. The LCD should now
display “Calibrate EL In Progress.”
After a few moments, the TRAV’LER interface box will display “On EL Hard Stop?/
Yes *No.” Check that the antenna is against the hard stop.
TIP
If the antenna is against the hard stop, the antenna will be pointing upward
as far as it can go.
Press
[SELECT]
to move the asterisk to “Yes” if the antenna is against its hard
stop.
Press
[ENTER]
, and the LCD will display “Calibrate EL Success.” Press and hold
[POWER]
for two seconds to stow the antenna.
Using the smaller cardboard box,
place two sheets of void fill in the
box so that they form an ‘X’.
Push the two sheets of void fill to the
bottom of the box.
Place the removed parts into the box with original packaging, and ship to Winegard
Company at 3111 Kirkwood St., Burlington, IA 52601.
Re-packaging the Removed LNB for RP-SK21 Users
NOTE
Only the LNB and cables need to be returned to Winegard. Remove the LNB and cables
from the arm assembly, then follow the steps below.
NOTE
If returning a replaced product to Winegard,
please follow the steps below.
1
2
3
4
5
6
Re-packaging the Removed LNB for OE-DISH Users
1
2