Follow the steps below to raise the antenna for reflector, bracket, and LNB assembly
removal.
Pay attention to the pinch points as the antenna raises.
See below.
Press
[POWER]
, and hold for two seconds to turn on
the TRAV’LER
®
interface box. Wait until the interface
box finishes “connecting to antenna.” The TRAV’LER
antenna may enter the search routine after ten seconds.
As the antenna raises, press
[POWER]
and
[SELECT]
at the
same time. The antenna should stop moving.
Unplug the TRAV’LER interface. Continue with reflector
removal.
If you cannot get the antenna to raise by following the above instructions,
you may have to raise the antenna with the emergency manual stow drive.
Emergency manual stow is meant as a last resort!
Unplug the TRAV’LER interface, and remove the
plastic bolt from the back of the mount.
Insert a
3
/
8
inch socket extension into
this auxiliary drive. Turn the auxiliary
drive counterclockwise to raise the
unit. Do not use a drill!
After raising the unit, continue with the
next section to remove the reflector
and LNB assembly.
Pinch Point
Top View
Side View
Pinch Point
3
1
Plastic bolt
Raising the Antenna
2
1
2
3