1
2
3
5
4
6
7
8
9
The receiver may run data feed and
guide feed tests for a few moments.
Then, you will be prompted to set up
the remote. Select “
Setup Remote
Later
” to do this at a later time.
Select “
Watch DIRECTV
.”
You are now ready to watch TV!
Once your setup is verified, you may
need to download a program guide.
If so, press “
Continue
” when the
status bar reaches 100%.
Select
“
Continue
” to verify your setup.
Select “
01: SWM
” for the switch
type. Set the dish type for
“
17: Slimline-3S (SWM)
.”
If required, press the
DASH (-)
(underneath #7 on your remote).
Select “
Satellite
.”
Select “
Repeat Sat Setup
.”
Press “
Menu
” on your remote. Under
“
Settings
&
Help
,” select “
Settings
.”
DIRECTV HD Receiver Setup
The following instructions assume that the TRAV’LER antenna has found and locked onto satellites 99°, 101°, and
103°. There should be an asterisk next to 99°, 101°, and 103° on the TRAV’LER interface.
In most receivers, the setup is done through the “Repeat Satellite Setup” option in your receiver menu. To access
the “Repeat Satellite Setup” option, go through the following steps. The following instructions are based on an H24
receiver. If your receiver differs from the options shown below, you may need to consult your receiver manual.
Check out online receiver setup guides for your antenna at www.winegard.com/receivers/setupguide.php.
2
