Select
Test
.
It will go through a number of
steps, then return to the screen
shown here with previous
information cleared.
If at any point it asks you to save,
select
Save
or
Yes
.
Reconnect the coaxial cable to the “Sat In” port
on back of receiver. Now
turn on
the antenna
. Allow it 3–4 minutes to acquire satellites.
(
If you have an In-Motion system,
after the search routine is complete the system
will take another 6 minutes before going into “Sleep Mode”. Once it does, the unit
will be completely silent.
Do not proceed to Step 6 until this has happened.
)
Move over to select
Check
Switch
.
Check that there are no
checkmarks by SuperDISH or
Alternate.
Next, select
Test
again.
This time it will install the
SW64 switch.
This SW64 switch
is a DISH receiver setting, not a
physical part.
When you see the SW64 as the
installed switch, the antenna is ready for use.
Mission Antenna 8
4
5
6
DISH Receiver Setup
