Figure 4
Main Port
Secondary Port
Quick
Disconnect
Socket
Coax Cable
Figure 5
Cable
Entry
Plate
TV
Coax Cable
120V Power
Receiver
TV
120V Power
Receiver
Mi
ssion
Nicks or cuts in wiring jacket may cause water to leak into vehicle.
Connect the quick disconnect power cable to the quick disconnect socket on
the back of the RoadTrip Mission unit. See
Figure 4
below.
Decide the best location for the power and coax cables to enter the vehicle.
Decide the location of the power switch and receiver. Drill a ¾” hole in the
roof, and push the wires inside, making sure the cables are accessible from
the area where the power switch and receiver will be located.
Connect a coax cable from the “Satellite in” port of the primary receiver to
the main port on the back of the RoadTrip Mission unit. For a two receiver
or dual tuner (DVR) installation, connect a second coax cable (not provided)
to the secondary port on the back of the RoadTrip Mission unit. Note: the
secondary receiver will not toggle.
Place the provided cable entry plate over the hole and cables. Screw the
plate in place. Seal the plate and screw holes with approved sealant (not
included).
Depending on the length of the cable, you may need to use cable clamps or wire
ties (not provided) between the unit and the cable entry plate. Clamping every
12–16” should eliminate any unnecessary cable movement.
Overall Installation
4
3
2
1
Installing the Cables
5 Mission Antenna