FIGURE 1
STEP 2. Place assembled mount on bottom of antenna
housing and thread in 1" aluminum bolt. Spin the as-
sembled mount to tighten securely.
STEP 3. Attach end of coaxial downlead cable with boot
to jack on bottom of antenna and slide boot up over boot
collar. See Figure 3.
FIGURE 2
FIGURE 4
STEP 4. Select location for antenna on roof of vehicle.
Try to position antenna about 24" from edge of vehicle
roof, convenient to downlead entry point and as far
away as possible from roof mounted equipment such as
air conditioners or roof vents. See Figure 4.
FIGURE 3
NOTE: Holes for mounting brackets are at corners
of 19-5/8" triangle. We recommend you make a
template from 19-5/8" triangular piece of cardboard.
Try to locate holes on roof rafters on other solid
members inside roof. See Figure 5.
19-5/8"
19-5/8"
19-5/8"
STEP 5. Drill six 1/8" pilot holes as shown in Figure 6.
Apply non-hardening silicone caulking compound around
holes under each bracket. Attach antenna to roof with
#10 x 1" thread cutting screws.
STEP 6. The power supply/wall outlet assembly may be
flush mounted in most standard electrical boxes. To
flush mount cut a hole in wall to fit the box. Run 2 #12
wires between wall outlet and 12 VDC source and route
downlead cable to this location. Install cable between
set 2 outlet and power supply SET 2 jack at this time.
See Figure 7.
WARNING: DO NOT CONNECT 12 VDC SOURCE TO
POWER SUPPLY AT THIS TIME. POWER SUPPLY
MAY SHORT, IF 12 VDC SOURCE IS CONNECTED.
ANTENNA MOUNTING INSTRUCTIONS
STEP 1. Assemble mounting brackets onto mounting
plate. Insert 10-32 x 5/8" bolts through mounting plate
and mounting brackets. See Figure 1. Attach #10 x 9/16
x 1/6 washers and 10-32 locking nuts. Tighten securely.
FIGURE 6
FIGURE 5
LOCATE HOLE OVER
RAFTERS OR OTHER
SUPPORTS IN ROOF
ROOF MOUNTING
BRACKETS
(3) #10 x 1" THREAD
CUTTING SCREWS
APPLY APPROVED NON-HARDENING
CAULKING COMPOUND UNDER
EACH BRACKET.
