53
6. If search satellite and search method is correct (correct city, elevation, etc.)
return the positioner to factory default. See Return To Defaults, page 6.
If after returning the positioner to factory defaults and reentering the correct city
and satellite the system still does not find the satellite proceed to the next step.
You will need a voltmeter or Winegard Model TE-1400 voltage tester for steps
7 through 10.
7. Check for +12 to +19 VDC at LNBF coax connector, see Figure 2. If correct
voltage is present, proceed to step 11; if there is no voltage, proceed to next
step.
8. Remove the coax downlead from the
SAT IN
jack on the rear of satellite
receiver. Connect a short piece of coax to the
SAT IN
jack on receiver, check
for +12 to +19 VDC. If voltage is correct proceed to step 9; if voltage is not
present verify the receiver is plugged into AC power. If there is no voltage
coming out of the
SAT IN
jack on the receiver, contact the manufacturer of the
receiver. RCA 800-377-3399, Sony 800-838-7669, Dish Network 800-333-
3474.
9. Remove coax downlead from
TO RECEIVER
jack on positioner. Check for
+12 to +19 VDC at coax connector. If voltage is correct proceed to step 10; if
voltage is not present verify the receiver is plugged into AC power and coax is
connected to
SAT IN
jack on receiver. If there is no voltage, the coax is
defective, repair/replace as required.
10. Reattach coax to
TO RECEIVER
jack on positioner. Remove the coax
downlead from the
TO ANTENNA
jack on positioner. Connect a short piece of
coax to the
TO ANTENNA
jack on positioner, check for +12 to +19 VDC. If
voltage is correct, the coax coming from the antenna is defective. Repair/
replace as required. If voltage is not present, verify the receiver is plugged into
AC power. No voltage coming out of the
TO ANTENNA
jack on positioner
indicates that positioner is defective. Contact Winegard Service Department
before returning unit to be repaired.
11. Replace LNB with new one. If system still will not find satellite, replace
positioner. If system still does not find a satellite, contact Winegard Service
Dept.
Figure 2
Coax Center
Conductor
