46
POSITIONER CONTROLS & INDICATORS
Positioner front and back panel wiring and controls.
See Figure 41. The call-outs explain panel controls,
indicators and wire connections. If you need information
on system installation, refer to the Installation Manual.
1.
SELECT A:
Selects command/option displayed on
top line of display.
2.
SELECT B:
Selects command/option displayed on
bottom line of display.
3.
DISPLAY:
Liquid Crystal Display (LCD).
4.
LEFT:
Left arrow button, when pressed moves
cursor left, or moves antenna left if in manual movement.
5.
UP:
Up arrow button, when pressed, causes screen/
letter to scroll up or antenna to raise if in manual
movement.
6.
RIGHT:
Right arrow button, when pressed, moves
cursor to move right, or moves antenna to right if in
manual movement.
7.
DOWN:
Down arrow button, when pressed causes
screen/letter to scroll down or antenna to lower if in
manual movement.
POSITIONER CONTROLS & INDICATORS
8.
TO RECEIVER:
75 ohm connection to satellite
receiver. There is +13 to +17 VDC present on the center
conductor of this jack (used to power LNBF).
9.
TO ANTENNA:
75 ohm satellite signal input from
the LNBF on the antenna. There is +13 to +17 VDC
present on the center conductor of this jack (used to
power LNBF).
10.
Control Wires:
These 13 wires control the mount.
There are various DC voltages present on these wires.
11.
REMOTE CONTROL PANEL:
This modular
telephone type plug connects the positioner to the
optional remote control wall plate (optional).
12.
AC POWER CORD:
Connect to 110 VAC outlet.
13.
46 CM - 60 CM:
Selects what size antenna the
positioner is controlling (46cm = 18", 60cm = 24").
Switch was removed 2/16/98.
14.
IGN:
Ignition switch signal connection (optional).
15.
WARNING INDICATOR:
This jack connects the
positioner to the Warning Device.
Rev. 2/98
