8
Initializing & replacing the dome after
connecting the receiver(s) —
1. Park vehicle where it is free of all obstructions and
with a clear view of the satellite.
2. DO NOT MOVE VEHICLE during the first initial-
ization. Power up unit, turn on receiver. FOR THE
FIRST TIME ONLY, the unit may take up to 10 min-
utes to initially find the satellite signal. The GPS is
also initializing at this time. After the GPS initializes,
the unit will begin searching for the correct satellite.
3. If the GPS does not initialize at this time, turn
off the unit. You may need to move the GPS antenna
to a different location on your roof. After moving the
GPS, DO NOT SECURE TO ROOF.
4. TEST YOUR SYSTEM BEFORE SECURING
THE GPS ANTENNA. Make sure the TV and re-
ceiver have the correct satellite.
5. After correct satellite is found, secure GPS antenna
by removing adhesive backing and securing to roof.
6. Tighten Heyco connectors and apply bead of sili-
cone around the connector where the exterior hex nut
touches the base, and around the cables where they
enter the exterior of the Heyco connector. Before se-
curing the dome, fill ovals in rubber gasket with
silicone and apply silicone to screw threads.
Installation • Wiring
Connecting the receiver —
1. Connnect the coax cable from the roof to the “Sat-
ellite In” connection on the receiver.
Satellite Receiver
SAT IN
(A dual receiver upgrade kit is available for this
model, MV-6000 (must be used with kit MV-1202).
Contact Winegard Company for more information.)
How to apply silicone —
FILL OVAL
WITH SILICONE
FILL SCREW THREADS
WITH SILICONE
BEFORE INSERTING
HEYCO CONNECTOR
APPLY SILICONE BEAD AROUND
COAX ON OUTSIDE OF DOME
APPLY SILICONE BEAD AT BASE OF
HEYCO ON OUTSIDE OF DOME
