Select a Location:
The most important factor in finding the satellite is the location of the satellite dish. This is because the
satellite signal will not pass through solid objects. Trees, plants, people, vehicles, buildings, signs and even
glass will all block the satellite signal. Because of this, it is vital to select a location with a clear view of the
southern sky.
The next thing to look for in a location is traffic. How likely is someone to disturb the MP1 by tripping over or
driving into it? Does the coax cable cross a walking path or will people have to drive over the cable?
Finally, try to select a location that will allow the MP1 to sit level. The closer the unit is to level, the more
accurate the look angles are for each search. This makes finding a satellite much easier.
Separate and Secure the MP1:
Once separated, place the TOP half with the reflector facing UP on the base. DO NOT use the LNBF or the
reflector as a handle.
Remove the twist off cap from the top half of the MP1 and fill the TOP with water or sand. This will provide
enough weight for the unit to stay on signal in most conditions. However, it is recommended that the unit be
filled with sand in situations where the temperature could stay below freezing for more than a few hours. The
case can be damaged if water is allowed to freeze inside the unit for an extended period of time.
Getting the Receiver ready for the MP1:
DIRECTV users can skip the following step.
DISH Network receivers will often not show when they are on signal if they have incorrect check switch
information. For this reason, DISH Network users must clear their check switch before trying to search for a
satellite. To do this for MOST DISH Network receivers:
Press [MENU] on the DISH Network Remote Control
Press [6] for System Set up
Press [1] for Installation
Press [1] for Point dish and signal meter
Once on this screen, find CHECK SWITCH and select it. Once on the CHECK SWITCH screen, make sure
the receiver is NOT connected to a satellite dish. Run the test and save the results. This will prepare the
receiver for the MP1. If the receiver is not connected during the test, it will always get the correct result.
Connecting the Cable(s):
The satellite receiver powers the LNBF by sending voltage up the coax cable to it. This voltage can damage
many cable TV systems, so many things are designed to block this voltage. Items such as splitters, video
switches and many wall plates will stop the satellite signal. For this reason, it is important to run the cable
directly from the satellite receiver to the MP1 when searching for a signal.
For dual tuner receivers it will be necessary to connect two coax cables from the MP1 to the receiver.
2
