background image

Step 5

 

– Add approved sealant 

completely around the base and over 
each screw.

Step 6

 

– Connect the coax cable attached 

to the OTA antenna to the ANT IN F-Jack 
input of the Winegard power supply.

Step 7

 

– Connect the coax cable 

attached to the AM Antenna to the 
Audio Extension Cable (CL-FM06). Next 
connect this Audio Extension Cable into 
the AM/FM receiver.

Winegard

 offers the following installation 

steps for the Winegard Air 360:

Failure to follow these instructions 
could cause damage to the unit 
making it inoperable, as well as, 
possible damage to the vehicle on 
which it is installed.

Step 1

 – After selecting a spot on the 

vehicle for the antenna, drill at minimum 
a 1 inch hole for two coax cables 

(only 

one provided)

 to run from the antenna to 

the Winegard power supply and from the 
AM/FM antenna to the AM/FM receiver 

(not provided)

Do not seal this hole

Step 2

 – Next, connect the coax cable to 

the Over-The-Air (OTA) antenna F-Jack 
located centrally under the dome. If AM/
FM is desired, connect a coax cable 

(not 

provided)

 to the F-Jack on the AM/FM 

antenna located on the base of the AM/
FM antenna. Route both coax cables 
through the 1 inch hole created in step 1.  

NOTE:

 To ensure a reliable signal, it is 

recommended to use RG-6 coax no longer 
than 30 feet from the roof antenna to the 
wall plate. 

Be sure to tighten the coax cables 
to the F-Jacks (finger tight plus  
1/8 turn).  
Failure to do so may cause the 
signal to become intermittent  
or unusable. 

Step 3

 – On the edge of the flange you 

will notice 2 

FRONT

   

          

 labels. 

These labels should be facing the front 
of the RV on one side and the rear of the 
RV on the other.

Step 4 

– It is recommended to use Butyl 

tape for extra protection under the flange 
before screwing to the roof. 

NOTE: 

Before using the supplied 

mounting screws, check with your vehicle 
manufacturer for any special screw 
requirements.

Screw in 6 approved mounting screws 
into the 6 mounting holes around the 
flange and into the roof.  

Installation Instructions 

REAR

Audio Extension 

Cable (CL-FM06)

Vehicle's 

Roof

6X Mounting 

Screws

 

(Not Included)

AM

/FM

 Antenna

TV Antenna

Min. 1" Thru Hole

TV 2

CABLE IN

TV 1

AM Antenna

TO AM/FM 

RECEIVER

Red Wire +12V DC

 

Black Wire Ground

SATELLITE

RV-0752

6X Mounting Screws 

AM/FM Antenna

Vehicle Roof

Min 1" thru Hole

To AM/FM  

    Receiver

Audio Extension 

Cable (CL-FM06)

AM Antenna

Satellite

TV Antenna

TV 2

TV1

       Cable In

Black Wire 

Ground

Red Wire +12V DC

CAUTION: Do not 
overtighten the mounting 
screws. This could cause 
the plastic flange to break.

Reviews: