15
Freestanding Installation
1.
Remove Drip Pad from plastic bag and install in unit by lifting up on the spring-
loaded drip tray. (See Fig. 1 on page 14)
Note
: The pad must be installed in the correct position. The pad must be installed with
the black
spot “Up”, next to the drip tray. Swing the drip tray and drip pad back to a
vertical position to finish the assembly of the drip pad.
2.
Attach the access panel and rotate (2) captive latches to secure the access panel
to the humidifier housing.
3.
Determine where unit will be mounted.
a.
If wall mounted, use surface mount unit (99H0174-21 and 99H0185-21 for
60Hz. 99H0176-21 and 99H0186-21 for 50Hz) Secure bracket to wall
(Refer to Fig. 2 on page 14). Attach humidifier to the bracket (with drain
tube on bottom) using four (4) screws provided (See Fig. 4 on page 14).
b.
If shelf mounted, place humidifier on shelf with drain tube on bottom. You
may need to drill a 1” (2.5cm) diameter hole in the shelf and route the
drain tube through the hole.
4.
Install a ¼” (.635cm) water line from the water supply to connection at the top of
the humidifier (see Fig. 7 on page 14). A shut-off valve (not provided) is
recommended to isolate the humidifier from the water system when needed.
5.
Install a ½” (1.2cm) flexible drain line from the bottom of the humidifier to an open
drain or connect into the drain line from the cooling unit.
Proceed to Steps 6 & 7 for humidifier part number:
99H0174-21 (60Hz)
99H0176-21 (50Hz)
Proceed to Steps 8 & 9 for humidifier part number:
99H0185-21 (60Hz)
99H0186-21 (50Hz)
6.
Humidifier part number 99H0174-21 uses the Remote or Local Interface
Controller at the Wine Guardian system to monitor and control humidity. Plug
communication cable from humidifier into the connection at the Wine Guardian
unit (see Fig. 8 on page 14). The communication cable provides power and
control signals to humidifier from Wine Guardian main control panel.
7.
Proceed to set up of the Remote or Local Interface Controller at Wine Guardian
unit to reprogram for humidity control. Starting on page 22
8.
Install the humidistat on the wall where it is open to the cellar and can be read
easily, approximately 60" above the floor. See section on Humidistat Mounting on
page 25.
9.
Plug transformer plug into wall outlet. The humidifier should now be operational.
Summary of Contents for 99H0173-20
