’
Solution
1.)
Set dome and recovery tank to the
side.
2.)
Use a clean bucket to
fill
the solution
tank with hot water.
CAUTION
Do
not use water temperatures in excess
of
F
(65°C).
Water which is too hot may distort the
polyethylene tanks.
3.)
Add a cleaning concentrate for use
in hot water extractors. Closely follow
manufacturer’s instructions found on
container. Read ingredients listed on
the container to ensure compatible
chemicals are used. The solution tank
capacity is 6 gallons
(23
liters).
CA
ON
:
Use only the suitable chemicals listed
below. Using incompatible chemicals
will
damage the machine. Damages of
this type are not covered under the
6-3-1
warranty. Carefully read ingredients on
manufacturer’s label before using any
product in this machine.
SUITABLE
CHEMICALS
Alkalis
Clorox Bleach’
Defoaming Agents
Detergents
Hydroxides
Oxygen Bleaches
Soaps
Sta-Puf Fabric Softener’
Vinegar
White Monday Bleach’
I
B
LE
CHEMICALS
Aldehydes
Aromatic Hydrocarbons
Carbon Tetrachloride
Clorox’
Chlorinated Bleaches
Chlorinated Hydrocarbons
D-Llmonene
Methyls
(MEK)
Phenols
Trichlorethylene
4.)
Place the recovery tank onto the
solution tank.
5.)
Set the dome in place on the recovery
tank. Dome must be seated correctly to
ensure
proper vacuum seal.
Rev.
1
Lower brush housing to the floor.
Turn the control knob until the pin lines
up with the slot
in
the bracket and the
housing comes down.
With the brush housing lowered, turn
control knob clockwise to lower or
counterclockwise to raise
the
brush
housing assembly,
as
shown on knob.
Lower brush while looking under
machine until brush bristles contact
the carpet. The amount of contact
required to clean the carpet will vary
depending on the carpet. Try different
amounts
of
brush pressure until the
desired result is achieved. More than
(lcm) of contact between the
brush bristles and carpet may cause
the brush motor circuit breaker to trip,
turning off machine.
of
engagement will be sufficient to clean
most carpets.
Storage
1/4
inch
most carpets
Do Not
Brush In
I
I
I
