Windsor Saber Compact 22, User Manual

Page: 18 / 72

18
English
Î Press the pedal for changing the brushes
downward beyond its resistance.
Î
Drive the appliance in reverse till the disk
brush is free.
Î
Remove the disk brush and place the
new disk brush in front of the appliance.
Î Drive the appliance forward over the disk
brush.
Î Press the pedal for driving out the run-
ning gear and lock it to the left. The
brush will lock into the brush drive.
Î Set the advance speed.
Î Empty the dirty and fresh water tank.
Î Remove the detergent bottle from the
detergent holder.
Î Loosen the tank fastening screw and tilt
the tank upward.
The metering pump is located behind the
batteries.
1 Covering lid
2 Cover
3 Hose switch
4 Pump hose
5 Rotor
Î Remove covering lid.
Î Remove cover.
Î Remove the hose holder with the pump
hose (turn manually to remove the rotor
manually).
Î Replace pump hose.
Î
Metering pump and appliance are brou-
ght into operational state by performing
the same steps in the reverse direction.
To ensure a reliable operation of the ap-
pliance maintenance contracts can be con-
cluded with the competent Windsor sales
office.
In case of danger of frost:
Î Empty the fresh and dirty water reser-
voirs.
Î Store the appliance in a frost-protected
room.

Danger
Risk of injury. Turn the program selection
switch to "OFF" and disconnect the mains
plug before performing any works on the ap-
pliance. Also turn the key switch to "0" and
press the emergency stop switch.
Î Drain and dispose of the dirty water and
the residual fresh water.
In case of faults that cannot be remedied
using the table below please contact the cu-
stomer service.
Note
If the display shows interruptions, first set
the program selection switch to OFF or dri-
ving and switch off the key switch (if availa-
ble). Wait for 15 seconds. Turn on the
appliance again. If the display still shows a
fault, then rectify the fault according to the
following table or call Customer Service.
Replace pump hose
Maintenance contract
Frost protection
Troubleshooting