Windsor Saber Compact 16 SP, Service Manual

Page: 12 / 53

English
11
The battery control display shows the charg-
ing status of the batteries when the charger
is unplugged:
To improve the vacuuming result on tiled
floors the squeegee can be turned to an ob-
lique position of up to 5°.
Î Release the wing nuts.
Î Turn the squeegee.
Î Tighten the wing nuts.
If the vacuum result is unsatisfactory the in-
clination of the straight squeegee tool can be
modified.
Î Release the wing nuts.
Î Tilt the squeegee tool.
Î Tighten the wing nuts.
Î Turn the running gear to the back with
your foot.
Î Turn the program selection switch to the
desired cleaning program.
Î Set the water quantity according to the
degree of dirt accumulation and the floor
covering.
Î
Lower the squeegee tool.
Î
Turn on the brushes by pulling the con-
trol handle.
몇
Warning!
Risk of damage to the floor covering. Do not
operate the appliance on the spot.
Î Close the water quantity regulator.
Î Drive the appliance forward for another
1-2m to draw off residual water.
Î Turn the program selection switch to "OFF".
Î Raise the squeegee tool.
Î Swing the running gear to the front using
your foot.
몇
Warning!
Danger of deformation of the brush(es).
When shutting down the appliance, relieve
the brush(es) by swinging the running gear
forward.
Note
If the dirty water reservoir is full the float
closes the suction channel. The suction op-
eration is interrupted. Empty the dirty water
reservoir.
몇
Warning
Please observe the local provisions regard-
ing the wastewater treatment.
Î
Take the dirty water discharge hose from
the support and lower above a suited col-
lection device.
Battery control display
40-100% lights green
20-40% lights yellow
0-20% slowly flashes red
empty lights red
Setting the Squeegee
Oblique position
Inclination
Cleaning
Shutting Down the Appliance
Emptying the Dirty Water Reservoir