OPERATIONS
D-250 98637 01/19/99
5
EQUIPMENT SET-UP:
1.) Plug power cable from machine into
properly grounded wall outlet.
2.) Turn vacuum motor switch on and off
to make sure there is electrical power at
machine.
3.) Connect vac hose to machine. Slide
the swivel cuff over the outlet on the tank.
4.) Connect the hose set to the machine
and wand. Pull back the knurled collar on
the quick disconnect coupler and push onto
the connection on the chassis. To avoid
leaks, check to be sure a positive
connection was made.
5.) Using a clean container, fill the
solution tank with clean, hot water. Mix in a
non-foaming cleaning concentrate for use in
hot water extraction machines following the
manufacturer's instructions, as printed on
the container
. When using a powder
cleaner, premix with hot water in a clean
container before adding to the solution
tank.
6.) Turn pump and vacuum switch to the on
position.
7.) Start cleaning.
NOTES:____________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
___________________________________
Serial
Number:____________________________
_____________
Date
Purchased__________________________
______________
