12
Operations
Pre-Run Inspection
1.
Check all fittings and connectors for proper
assembly.
2.
Check all hoses for leaks. Repair or replace any
damaged hoses.
3.
Check power cord(s) for any damage. If damaged,
replace.
Equipment Set-up
1.
Plug power cord from machine into properly
grounded wall outlet.
2.
Turn vacuum motor switch on and off to make sure
there is electrical power at machine.
3.
Using a clean container, fill the solution tank with
clean hot water. Do not use water over 130°F. Mix
in a non-foaming cleaning concentrate for use in
hot water extraction machines, following the manu-
facture's instructions printed on container.
4.
Connect priming hose to solution fitting on
machine. Turn on pump and run for 30 seconds or
until a steady flow of water is coming out of priming
hose. Turn off pump and disconnect priming hose.
5.
Connect vacuum hose to machine. Slide the swivel
cuff over the outlet on the tank.
6.
Connect the hose to your machine and wand. Pull
back the knurled collar on the quick disconnect
coupler and push onto the connection on the
chassis. To avoid leaks, check to be that a positive
connection was made.
NOTE: When using a powder cleaner, pre-mix with
hot water in a clean container before adding to the
solution tank.
7.
Turn pump and vacuum switch(es) to the on
position.
8-639-921-0 Operators Manual - Dominator 200 psi 230V / 240V 13 gal
