Windsor BSCSC264, Operating Instructions Manual, Page: 31 / 97

31
Maintenance
Machine Troubleshooting
PROBLEM CAUSE SOLUTION
Poor or no water pick-up Squeegee out of adjustment Adjust squeegee
Debris caught on squeegee Remove debris
Worn squeegee blades Rotate or replace squeegee blades
Vacuum hose clogged Clear obstruction from hose
Vacuum hose disconnected from
squeegee or recovery tank
Reconnect vacuum hose
Vacuum hose damaged Replace vacuum hose
Recovery tank not sealed
Place recovery tank dome on tank.
Replace damaged gaskets.
Foam filling recovery tank
Empty recovery tank
Use less or different detergent
Use defoamer
Vacuum motor does not run, or
runs slowly
Recovery tank full Drain recovery tank
Recovery tank float system dirty Clean float system
Circuit breaker tripped Reset circuit breaker
Loose connection Check motor wires and connections
Faulty vacuum switch Replace switch
Worn vacuum motor brushes Replace brushes, check commutator
Poor scrubbing performance Debris caught in scrub brushes Remove debris
Worn brushes or pads Replace brushes or pads
Improper detergent, brush or pad used
Contact equipment or application
specialist
Low scrub brush down pressure Increase brush pressure
Low battery charge Charge batteries
Brush motors do not run, or
runs slowly
Circuit breaker(s) tripped Reset circuit breaker(s)
Loose connection Check motor wires and connection
Faulty brush motor contactor Replace contactor
Worn brush motor brushes Replace brushes, check commutator
86039070 CUTTER 24V