Windsor 10060140, Operator Instructions Manual, Page: 27 / 128

MAINTENANCE-BATTERIES
86037880 CHARIOT EXTRACTOR 01/16/07
4-5
1. Replace the battery caps, and leave them in
place while charging.
2. Unplug the battery connector from the machine.
FOR SAFETY: When charging, connect the
charger to the batteries before connecting the
charger to the AC wall outlet. Never connect the
charger to the AC wall outlet first. Hazardous
sparks may result.
3. Plug the charger connector into the battery
connector. Connect the charger AC plug to a
wall outlet. The charger gauge should indicate
that the batteries are charging.
4. When the batteries are fully charged, disconnect
the charger from the AC wall outlet, then
disconnect the charger from the batteries.
5. Connect the batteries to the machine connector.
6. Check the electrolyte level. It should be up to
the indicator ring. If necessary, add distilled
water.
7. Install the rear cover.
CHANGING BATTERIES
Stop the machine in a clean area next to the
charger. Turn off machine.
FOR SAFETY: Before leaving or servicing the
machine; stop on level surface, turn off machine
and remove key.
1. Remove the rear cover.
2. Disconnect battery pack from machine.
3. Unlatch battery tray from machine and pull out to
expose batteries.
4. Use the proper size open-end wrench to
disconnect main ground wire first and secure
cable terminal away from batteries.
5. Disconnect main positive lead and secure cable
terminals away from batteries.
6. Loosen both terminals on each jumper cable
and remove one at a time.
7. Prepare a suitable site to place the batteries.
8. Attach suitable battery lifting device and lift
batteries from the machine.
Batteries are a potential
environmental hazard.
Consult your battery supplier for safe disposal
methods.
+
- -
+ +
-
RED
BLK
RED
BLK
RED
BLK
REAR OF MACHINE