Windsor 10052870, Operator Instructions Manual

Page: 32 / 92

MACHINE TROUBLESHOOTING
CUTTER 24V 86039070 04/10/07
4-14
PROBLEM CAUSE SOLUTION
Little or no solution flow to the floor Solution tank empty Fill solution tank
Solution flow turned off or set
too low Turn on or increase flow
setting
Solution strainer plugged Clean solution strainer
Solution hoses obstructed Clear obstruction from hose
Solution solenoid valve
obstructed or stuck Clean or replace
Vent hole in solution tank lid
obstructed Clear obstruction from vent
hole
No power to machine Battery disconnected Check all battery cable
connections
Emergency shut-off activated
(If included) Reset
Battery connections corroded Clean connections
Faulty main contactor Replace contactor
Faulty key switch Replace switch
Little or no propel Low battery charge Charge batteries
Wheels spin Decrease brush pressure
Controller overheated Allow cool down period
Adjust brush shroud if needed
Loose connection Check motor wires and
connection