TH200E User Guide
2
General Safety Information
Please read the following items carefully before installing & using the printer.
Safety Instructions
Do not touch the printhead, it is hot and sensitive to ESD
(Electrostatic discharge)!
Do not touch the cutter and tear bar of the printer.
CAUTION:
Install the printer on a flat and stable surface.
If the printer is brought in from a cold environment, dewfall condensation
can occur. In case of such condensation, do not turn on the power until
the printer is completely dry.
Use a properly grounded power supply outlet. To disconnect the printer
from the power supply, switch off the printer first then disconnect the
power supply plug.
Always shut down the printer when plugging or unplugging interface
connectors to avoid damage to the controller board. Never plug or unplug
the interface connectors during thunderstorms.
Make sure that no objects (e. g. paper clips) or liquids get inside the
printer as they might cause electric shocks or short circuits.
Protect the printer from vibration, dust, moisture, heat and liquids.
Do not allow printing without paper rolls installed as it may cause damage
to the print head.
Use only certified power supplies and cables.
The printer should only be transported in its original packaging to protect
against damages from knocks and bumps.
The printer should be repaired by authorized personnel only.
Repairs made by an unauthorized service provider not only
could jeopardize the safety of the user, but could also lead to
the cancellation of all warranty and liability agreements.
