Wincor Nixdorf CINEO C1030, Installation Manual

Page: 10 / 35

Important Notes
6

In case of an accident (such as a damaged housing, entry of liquids or foreign
objects), switch the device off and use the separator to completely remove the
device from power.

CINEO C1030 is the result of state-of-the-art technology. Therefore, please also
ensure that the CINEO C1030 is operated under modern building and technical
conditions in order to ensure flawless and efficient operation. The appliance and
other information technology hardware should only be connected to electrical supply
networks with a separate protective earth wire (PE). This type of electrical supply
network is referred to as a TN-S network. Do not use PEN conductors.
Also follow the recommendations set forth in DIN VDE 0100 Part 540, Appendix C2 as
well as EN50174-2, §5.4.3, National Electrical Code ANSI/NFPA 70-2005 and Canadian
Electrical Code, Part I, CSA C22.1-02. This will help prevent malfunctions.

Turn off the device when working on the cutter of the printer.

Always keep the ventilation slots free of obstruction to ensure adequate air
circulation and avoid overheating.

Transport the appliance only in its original packaging (to protect it against
knocks and bumps).

If a lithium battery is supplied with the appliance, ensure that the battery is
replaced with an equivalent type. Otherwise there is danger of explosion!
Lithium batteries may only be replaced with identical types or other types
recommended by the manufacturer.

Batteries must be disposed of according to local regulations on the disposal of
special waste.
Connecting Peripherals
Use only shielded cables when connecting devices to the system to ensure compliance
with international Rules and Regulations for radiated emission as well as to achieve a
high immunity against external disturbances.
LCD Displays
If the display element is damaged and the liquid crystal solution leaks out onto your hands
or clothing, please wash your hands or clothing immediately under running water for at
least 15 minutes, using soap or alcohol. If the liquid comes into contact with your eyes, consult
a medical doctor immediately.
Before opening the device, make sure, that the device is disconnected from the main power
supply. Only authorized personnel is permitted to open the device.