Wincor Nixdorf BA72R, User Manual

Page: 9 / 48

Safety Instructions
3 BA72R LCD Display – Operating Manual 01750140683 F
Safety Instructions
This device conforms to the corresponding safety regulations for information
technology devices, including electronic office machines for use in the office
environment.

If the device is moved from a cold environment to a warmer room where it is
to be operated, condensation could occur. The device must be completely dry
before being put into operation. Therefore an acclimatization time of at least
two hours should be accounted for.

Lay all cables and supply lines so that nobody can tread on them or trip over
them.

Data cables should neither be connected nor removed during electrical
storms.

Protect the device from vibrations, dust, moisture and heat, and only transport
the device in its original packaging (to protect it against impact and blows).

Take care to ensure that no foreign objects (e.g. paper clips) or liquids can
get into the inside of the device, as this could cause electrical shocks or short
circuits.

In case of emergencies (e.g. damaged housing, liquid or foreign objects
getting into the device), the device should be switched off immediately, the
mains plug of the BEETLE or PC should be removed, and the Wincor Nixdorf
customer service should be contacted.

If the LCD display element is broken and the liquid crystal solution leaks out
of the display and onto your hands, clothing etc, wash your hands or clothing
immediately with soap or alcohol, holding them under running water for at
least 15 minutes. If the liquid comes into contact with your eyes, please
consult a doctor immediately.

Generally you should connect IT-devices only to power supply systems with
separately guided protective earth conductor (PE), known as TN-S networks.
Do not use PEN conductors! Please also observe the recommendations of
the norm DIN VDE 0100, part 540, Appendix C2, as well as EN50174-2,
§5.4.3.